AVCS LIVES!

There are two routes to installing AVCS…

1. Buy (or make) two wiring harnesses. The left hand side of car is for the AVCS solenoids & the right hand side is for the AVCS sensors.

2. Make a harness for only the right hand side and reuse the wiring from the USDM TGV system for the left hand side.
https://docs.google.com/open?id=0BxStszFs4sHHdllwRWZjS3FQUWs

Note: for the right hand side (the sensors) you must use individually shielded wire!

I went with option 1 because it is SIGNIFICANTLY easier. Pulling pins out of the harness is a royal pain. I wanted to save some time, so I purchased a pre-made wiring harness from IA Performance. With this kit, the install took me under 30 minutes to complete.

Addendum: The connectors of interest are the middle one on the ECU (smallest connector), the black bulkhead connector next to the battery, and the grey bulkhead connector next to the boost control solenoid.

Advertisements

AVCS CEL code disable

With the motor now installed and the car back in Chicago, I have a few posts to catch up on. This one will cover disabling AVCS codes that appear from plugging in the JDM motor wiring harness to the USDM connectors without the additional wiring required for AVCS. The reason I did this is so I can temporarily drive the car without CELs. Here is everything required:

– Tactrix cable ($150 for v1.3) & flash block
– RomRaider (free)
– ECUflash (free)
– Windows Laptop

The codes to disable are:
P1306, P1308, P0390, P0365

Follow these tutorials to disable them:
http://www.scoobypedia.co.uk/index.php/Knowledge/DisableSubaruFaultCodes